≡ Menu

Hybrid batteries are widely used in many places and used to store the power for UPS and vehicles. The hybrid batteries are an essential part of the cars and vehicles. Therefore, it is important to have a good and charged hybrid battery.

Many people think that reconditioning the hybrid battery is not safe, time-consuming and hard but it is not the case. The reconditioning of the hybrid battery can be done personally and with the help of a professional as well.

Why reconditioning of the hybrid battery is important?

Rather than wasting your money every time on the buying a new hybrid battery, you can get it reconditioned. There are many reasons to get your hybrid battery reconditioned; some of the reasons are listed below:

1. Reconditioning hybrid battery saves your money:

Purchasing a new battery after some time can cost you more than you think; therefore you can save a lot of your money by reconditioning your hybrid battery. Replacing your hybrid battery with a new one can cost you $4500 on an average.

You can also buy an old hybrid battery in very less price and for free as well, get it conditioned and save you precious money.

2. Reconditioning hybrid battery will save the earth:

Most of us use hybrid batteries thinking that it is good for the planet, but most of the hybrid batteries end up in the trash which is harmful to the earth. But when these batteries are reconditioned, it will be beneficial for the planet as well.

3. Reconditioning hybrid batteries is easy too:

For those who think that the reconditioning of the hybrid battery is hard, this is not the case. The hybrid battery is very easy to recondition, and you can do this in your personal garage or with the help of your car mechanic as well.

4. Reconditioned hybrid batteries save time:

Rather than being stuck with bad hybrid battery and spend hours in starting your car, save and invest your time to recondition your hybrid battery.

How to recondition hybrid battery at home?

Reconditioning of the hybrid battery is quite an easy task when you have the right equipment and knowledge. It can be done at home garage easily.

• What do I need?

You will need hybrid battery recondition kit which consists of equipment for battery reconditioning. A professional kit comes with a guide to perform the task step by step.

The reconditioning of the battery is a process in which the battery cells restore its original capacity which is lost over time and improves the ability to equalize the cell voltage. After the process, the capability of the battery is improved, and the vehicle can benefit from it.

• How to do it?

The hybrid battery reconditioning has major two elements:

1. Balancing/charging battery:

In this step, the battery is charged until it stops further charging, and the balancing of charge is done.

2. Deep discharging process:

In this process the recondition of the battery is done again and again which will dissolve the formation of crystals as well as reduce the depression of voltage in the battery resulting in improved performance.

The manual of battery reconditioning kit listed the step by step process of reconditioning the battery by yourself and thoroughly guide you how to use the equipment as well.

Like many things, a car batteries’ performance degrades over time, and hundreds of dollars are spent on replacing dead batteries with brand new ones. Luckily, you needn’t waste your money; there’s an inexpensive way you can get a working car battery – just refurbish an existing one! This article will not only save you money on replacing the whole battery but will also demonstrate that you don’t have to buy expensive chemicals. You can get a car battery in great working order once again, simply by using water and salt. Here’s how you can bring your dead car battery back to life, in just a few short steps:

Safety first.

Over 2,300 people in the United States sustain car battery-related injuries including burns to the face and body, so don’t add to that statistic!

Before you even touch the battery, make sure you’ve taken the necessary precautions to avoid a nasty accident. As you’ll probably be aware, car batteries contain sulfuric acid, which is highly corrosive and can irritate the skin. It can also be highly flammable when not treated with care. We strongly advise following the below safety tips:

● Stay safe by wearing safety goggles, neoprene protective gloves, as well as a heavy duty apron to prevent acid from leaking onto clothes or exposed skin.

● We also advise you to work outdoors or a highly ventilated area, as batteries do release gasses that can be explosive when charging.

● Never leave the battery acid in direct sunlight or a hot location.

● Be aware that metal reacts with battery acid, so make sure that any metallic objects such as jewelry are removed and that only nonmetallic tools are used such as plastic funnels.

● Stay away from open flames when handling the battery, as even the slightest spark can cause an explosion.

To Begin…

Detach the battery from its cables and wash the outside with clean water and baking soda to prevent contaminating the inside of the battery. Make sure that all corrosion from the terminals and cable connections are scrubbed off. Next, mix 1/2 gallon of nearly boiling distilled water with 1/2 lb of Epsom salts and set aside, ensuring that the Epsom salts completely dissolve into the solution. This is the magnesium sulfate solution used to replace the battery acid.

Removing the battery cell covers

The battery cell caps can be removed by prying them off with a screwdriver. Remember to then drain the remaining water left in the battery as well as clean any residue around the exposed holes using a damp paper towel. Then, with a plastic funnel, pour the distilled water and salt solution into the cells until the lead plates are completely covered and then replace the cell caps. In order to ensure that all surfaces are completely covered by the solution, gently shake the battery around 10 times for even distribution.

Charging the battery

Now you need to attach the battery to the terminals and leave to charge on a slow trickle for 24 hours, repeating the process if you wish in order to prevent sulfur build-up and improve performance. Then, reinstall the battery ensuring that all connections are properly fastened. The battery should now be as good as new, and ready to use!

Learn more at EZBatteryReconditioning Review

Do you want to bring back to life your old or expired lead acid battery? Most motorists believe that an expired battery cannot be restored to its initial performance. They believe that such batteries such be thrown away. But all is not lost, as there is a way that you can use to get your l battery back to its full performance. If you are looking for information about how to recondition lead acid batteries, then you have come to the right place. You will be surprised to know that your expired or old will just work like a new one after reconditioning.

The process of reconditioning batteries is very simple and can be done by any person. All you require is the gadgets and an ample time to get your battery fully reconditioned. After reconditioning, your old or expired battery will have the same features and capacity similar to that of a new one. If you want to understand the process involved in reconditioning batteries, pay close attention to procedures that will be outlined below.

When you recondition your old or expired lead acid battery, you will make great savings. Secondly, you are going to reduce pollution caused by old batteries to the environment by almost 50%.

Basic Steps to follow when reconditioning lead acid battery for your car

A lead acid battery is the most valuable component in a car. It is always good to know that you can recondition them and get a brand new battery. It is important to note that a reconditioned lead acid battery will have a power output of 70% compared to the new ones. To recondition you lead acid battery you should follow the following steps carefully.

Items needed

  • Distilled water
  • A syringe
  • Battery charger
  • Voltmeter

Steps to be followed include the following;

  • You will be required to remove the lead acid battery from your car and get rid of the rubber that seals the caps.After that, you will be required to remove all the caps.An average lead acid battery contains at least 7 caps.
  • After removing the caps, add distilled water to the battery and start recharging it. Let the battery charge for the next one hour. The bubbles should start to form in the holes as charging continues.

If you do not see any bubbles, alternate the positive and negative wires and observe it for two minutes. By now you should have seen the bubbles. Return the wires to their original positions and charge the battery for around thirty minutes.

  • This is the last step in reconditioning your lead acid battery where you replace the old acid with a new one. It is important to remember that a fully charged battery should have between 13 to 14 volts when measured with a voltmeter.

Conclusion

It is always advisable to wear protective gloves as the lead acid used in this process is very corrosive. The battery should be charged for around 12 hours if you are using a slow charger.If you learn how to recondition lead acid battery, then you will make great savings and have a positive impact on the environment. Learn more at EZ Battery Reconditioning

The diminished battery-performance is a common issue we deal with in a daily life. Do not fret though, as the problem can easily be fixed at home and with ease. To begin with, it is important to know the structure, design and the chemical composition of the battery as well as the mixture of solution it contains. We shall look at an in-depth procedure on how to recondition a car battery at home but first things first.

Causes:

Car batteries normally die because of a very common chemical process involved. This reaction is known as sulfation. In simple words, it is the accumulation of Sulphur on the surface of lead plates and thus causing a blockage in the electric current.

Safety Precautions:

  • Since you are going to deal with sulfuric acid, don’t forget to wear protective rubber gloves as well as safety goggles. Avoid overfilling of the battery.
  • If you use the procedure for the reconditioning of a car battery but choose to do it inside a garage, then the garage should be well ventilated. This is how you can lower the risk of having flames.
  • Rinse you hand, just in case you come in contact with the acid.
  • Keep all the inflammable substances away for example cigarettes, to escape any serious accident.
  • Avoid leaning over the battery while testing, filling and charging.

 

Proper tool and items that are required to do the process of reconditioning include the following.

  • Plastic funnel
  • Battery charger
  • Magnesium sulfate
  • Distilled water
  • Plastic funnel
  • Drill
  • Voltmeter

Step by step procedure for reconditioning the car battery at home:

Test the Battery:

The battery must be tested using Voltmeter to ensure the entire procedure is not a waste of time. If it operates on 12 volts, you may proceed further. Leave any battery that won’t hold charge or one that produces below 10 volts.>

Prepare a solution of Magnesium Sulfate’s :

Take distilled water on half quartz and dissolve Epsom salt or Magnesium sulfate in it. Heat the mixture to a temperature about 150 degrees F. The mass of magnesium sulfate needed is 7 oz.

Remove the Caps:

The cell caps on the top of the battery need to be removed. If the battery cover is sealed, drill it. Take a wet paper towel and carefully clean the area around the holes.

Drain of the Battery’s fluid:

The battery fluid must be drained out so that the solution made up of magnesium sulfate can be poured inside the battery by use of a plastic funnel. Ensure to uniformly disperse the solution inside the battery. You need to shake it several times. Seal the battery by inserting the plastic plugs.

Recharge the battery:

Once you are done with the above-mentioned process, recharge the battery for one day. When it is fully charged, put it back in the car. It is highly recommended that you leave the battery for around 3 to 4 days to be charged so that the battery can get the maximum energy.

Battery should be properly stored:

When the battery is not needed, store it in a proper way at a proper place so that there is no undue refurbishing needed. In other words, you reduce the risk of going through whole procedure again and again. You can put the battery on a trickle charger if are not planning to use the battery for few weeks.

Learn more at EZ battery Reconditioning Review

 

With the advancement of technology, everything is made wireless nowadays. That requires the use of batteries which makes it an integral part of today’s technology. And for a long-life battery, you have to take proper care of it. A dead battery is very inconvenient and you have to spend much money on these batteries. Batteries are expensive and one cannot afford to buy a new battery every time. Which is why EZ Battery Reconditioning program lets you recover your used battery instead of buying a new one. This method has been known to increase the life span of the battery up to 5 times than its previous life.

What Is EZ Battery Reconditioning Program?

EZ Battery Reconditioning is created by Tom Ericson. it is a course about how to reconditioning dead batteries. This programs also contributes in nature preservation. A battery contains chemicals which shouldn’t be left in the garbage can. These chemicals can damage the quality of the soil as well. This program is applicable to every type of battery whether it be a small battery or a big one.

What you get from the program?

  • You’ll get knowledge of all aspects of battery reconditioning.
  • There are step by step instructions for how to repair your battery.
  •  You’ll know how much money you can save by applying this program.
  • Each instruction is attached to a diagram so it is very easy to understand.
  • You’ll know how can you extend your battery life span.

Why is it unique?

  • Simple materials are required for this program so you can save your money.
  • You can recondition any type of battery like car battery, laptop battery, and any other.
  • It tells you how you can sell your battery and profit from them.

Pros

  • EZ Battery Reconditioning is easy to understand and follow as it is user friendly.
  • It provides lots of techniques, tips, information and ideas about batteries.
  • This program is a cheap and effective way to recondition batteries.
  • There is a 60-day money back guarantee if you are not satisfied with the product.
  • You can save lots of money by following this program as there is no need to buy a new battery for a dead one. You can repair that battery by following simple techniques.
  • It is affordable and less expensive because you don’t need special tools for that. You can use simple household items to repair the battery.

Cons

Conclusion

This is a highly effective method to repair your old and dead batteries and prolong the life span of new and used batteries. You can easily understand the process as it provides a very user friendly step by step method with diagrams and charts. You can save a lot of money and help in nature preservation by repairing the batteries yourself. Any type of battery can be repaired as explained in the book.

Click Here To Visit The EZ Battery Reconditioning Official Website