≡ Menu

All you Need to Know About Reconditioning Your Lead Acid Battery

Do you want to bring back to life your old or expired lead acid battery? Most motorists believe that an expired battery cannot be restored to its initial performance. They believe that such batteries such be thrown away. But all is not lost, as there is a way that you can use to get your l battery back to its full performance. If you are looking for information about how to recondition lead acid batteries, then you have come to the right place. You will be surprised to know that your expired or old will just work like a new one after reconditioning.

The process of reconditioning batteries is very simple and can be done by any person. All you require is the gadgets and an ample time to get your battery fully reconditioned. After reconditioning, your old or expired battery will have the same features and capacity similar to that of a new one. If you want to understand the process involved in reconditioning batteries, pay close attention to procedures that will be outlined below.

When you recondition your old or expired lead acid battery, you will make great savings. Secondly, you are going to reduce pollution caused by old batteries to the environment by almost 50%.

Basic Steps to follow when reconditioning lead acid battery for your car

A lead acid battery is the most valuable component in a car. It is always good to know that you can recondition them and get a brand new battery. It is important to note that a reconditioned lead acid battery will have a power output of 70% compared to the new ones. To recondition you lead acid battery you should follow the following steps carefully.

Items needed

  • Distilled water
  • A syringe
  • Battery charger
  • Voltmeter

Steps to be followed include the following;

  • You will be required to remove the lead acid battery from your car and get rid of the rubber that seals the caps.After that, you will be required to remove all the caps.An average lead acid battery contains at least 7 caps.
  • After removing the caps, add distilled water to the battery and start recharging it. Let the battery charge for the next one hour. The bubbles should start to form in the holes as charging continues.

If you do not see any bubbles, alternate the positive and negative wires and observe it for two minutes. By now you should have seen the bubbles. Return the wires to their original positions and charge the battery for around thirty minutes.

  • This is the last step in reconditioning your lead acid battery where you replace the old acid with a new one. It is important to remember that a fully charged battery should have between 13 to 14 volts when measured with a voltmeter.

Conclusion

It is always advisable to wear protective gloves as the lead acid used in this process is very corrosive. The battery should be charged for around 12 hours if you are using a slow charger.If you learn how to recondition lead acid battery, then you will make great savings and have a positive impact on the environment. Learn more at EZ Battery Reconditioning

{ 0 comments… add one }

Leave a Comment